- This topic is empty.
Viewing 1 post (of 1 total)
-
Posts
-
Following is the preparation before applying the Black Vinyl car wraps:
1. Begin by measuring your vehicle from the outside of each door to the inside of each entry. Each measurement should be 2 inches less than the total width of your car.
2. Using a level and straight edge, mark where each piece will drop down over the door frame. For example, if you are applying two pieces of vinyl, measure 1 inch above and below the top edge of your door, now measure 1 inch above and below the bottom edge of your door and then mark these points on each piece of vinyl as well.
3. Next, use a marker to ensure that you have marked all four points on both pieces of artwork to match up when installed on your car, truck window, or door!
Viewing 1 post (of 1 total)